JCM Engineered Products Manual 8 24 2020

JCM 412 Fabricated Tapping Sleeve The JCM 412 Fabricated Tapping Sleeve is a safe, economical solution to tapping today’s pipelines. Custom engineering service assures proper fit and conformation to the pipe diameter increasing safety factor and installation efficiency. By directly reinforcing the pipe, the sleeve eliminates flexing or deflection of the pipe opposite of the tap. The large cross section gasket provides a positive initial seal which increases with increases in line pressure. The JCM 412 Tapping Sleeve is available in various option styles and materials. Call the JCM Sales Team with your requirements.

JCM 412 Fabricated Tapping Sleeve - Typical Specifications Tapping Sleeves shall be the high strength type having a wide body, made of ASTM A-36, ASTM A-516 Grade 70 or equal which conforms to and reinforces the pipe. The sleeves shall have as a minimum 7/8” wide recessed Buna-N gasket around the outlet, 3/4” corrosion resistant alloy bolts (per AWWA C-111, ANSI 21.11), a 3/4” forged steel test outlet and hydrostatic test pressure capability of 300 PSI in 12” and smaller outlet sizes. Flanged outlet shall be recessed per MSS-SP60. Tapping Sleeve shall be furnished with corrosion resistant shop coat paint primer. Optional Epoxy Coated sleeves shall be furnished with a 3/4” stainless steel type 304 plug in the test outlet. Tapping Sleeve for pipe sizes 36” and larger shall be of the heavy duty type with a body width of 4” wider than smaller sizes and integral strengthening of the outlet half to provide additional gasket sealing and pressure holding capability. Tapping Sleeves shall be JCM 412 or approved equal. Tapping sleeve shall be ANSI/NSF Standard 61, Annex G and ANSI/AWWA 372 Certified. JCM 412 Fabricated Tapping Sleeve - Material Specifications BODY : Carbon Steel per ASTM A-36, ASTM A-516 Grade 70 or equal. BOLTS : Corrosion Resistant, high strength low alloy A242. Optional Hardware: Stainless Steel 18-8 Type 304, 316; Electro Coated Hardware. FLANGE : AWWA C207 Class D, ANSI 150lb. Drilling, recessed for tapping valve MSS-SP60. Other flanges and outlet available upon request. GASKET : Nitrile rubber compounded for use with water, salt solutions, mild acids and bases. FINISH : Heavy coat of corrosion resistant shop coat primer. Optional Fusion Epoxy Coating (per ANSI/AWWA C-213) available. SERVICE RATING : 4” to 12” Outlets: 175 PSI. Higher service rating available for specific applications and sizes. JCM Industries Tapping Sleeves meet or exceed the ANSI/AWWA C-223 and MSS-SP 124 Standards as applicable. Note: Large diameter sleeves incorporate multi-section design.


Powered by