JCM 414 Fabricated Mechanical Joint Tapping Sleeve
The JCM 414 Fabricated Mechanical Joint Tapping Sleeve is recommended for taps on pipe that will not accommodate a direct outlet seal tapping sleeve. The 414 utilizes a true mechanical joint sleeve design that completely encompasses the tap area, eliminating any potential leaks due to pipe cracks or breaks. Side gaskets are internally and externally trapped in a recessed groove machined into the bolting lug bars that completely compress the gaskets creating the watertight seal on the sides of the sleeve. The end gaskets are compressed into the sleeve housing with mechanical joint end glands, providing the water tight seal on the ends of the sleeve and completing the full encapsulation of the tap area.
JCM 414 Fabricated Mechanical Joint Tapping Sleeve JCM 414 Fabricated Mechanical Joint Tapping Sleeve - Typical Specification Tapping Sleeve shall be of split mechanical joint design with separate end and side gaskets. The fitting shall be constructed of high strength steel, ASTM A-36, ASTM A-516 Grade 70 or equal. The mechanical joint end dimensions shall conform to AWWA Standard C-110/C-111. Split coupling designs are not acceptable. Tapping Sleeves shall be JCM 414 Mechanical Joint Tapping Sleeve or approved equal. T apping sleeve shall be ANSI/NSF Standard 61, Annex G and ANSI/AWWA 372 Certified. JCM 414 Fabricated Mechanical Joint Tapping Sleeve - Material Specification
BODY:
Carbon Steel per ASTM A-36, ASTM A-516 Grade 70 or equal. Optional 304 or 316 Stainless Steel. AWWA C207 Class D, ANSI 150 lb. Drilling, recessed for tapping valve MSS-SP60 Optional flanges available upon request. Corrosion Resistant, high strength low alloy A242. Optional Hardware: Stainless Steel 18-8 Type 304, Stainless Steel 316, Electro Coated Hardware. ASTM A-36 or Ductile Iron. Optional 304 or 316 Stainless Steel.
FLANGE:
GLAND: BOLTS: STUDS: GASKET:
B7 Material
Nitrile rubber compounded for use with water, salt solutions, mild acids and bases. Optional EPDM gaskets available.
COATING: Heavy coat of corrosion resistant shop coat primer, an excellent base for bitumastic coal tar or similar field coatings. Optional Fusion Epoxy Coating (per ANSI/AWWA C-213) available. JCM Industries Tapping Sleeves meet or exceed the ANSI/AWWA C-223 and MSS-SP 124 Standards as applicable.
23
Powered by FlippingBook